Heath Zenith Wireless Plug-In Chime 598-1067-03 Uživatelský manuál stáhnout pdf (Strana 4)

-4-

598-1067-03

Troubleshooting

A. Chime does not sound:

• Makesurepushbuttonandchimecodesarethesame(seeFigure5).

• Checkorientationofpushbuttonbattery(Seediagraminsidepushbutton

for correct battery orientation.)

• Checkchargeofpushbuttonbattery,replaceifnecessary.

• Makesuretheplug-inchimehaspowergoingtoit.

Chime is receiving

interferencefrom another wirelessdevice; change the code setting(see

Code Settingbelow).



• Donotmountchimeorpushbuttononmetalornearmetalstuds.This

reducesthetransmitterrange.Use1/4"to1/2"(6to13mm)woodshims

to move chime or push button off metal surface.

• Concreteoorsmayreducerange.Movechimeawayfromoor.

• Trylocatingchimeclosertopushbutton.

D. Code Setting:

       

        

reconnecting to power.

It is recommended to only change one code position at a time and then check

to see if system is functioning properly.

1. Unplugchimefrompowersource.

2. Open the cases and locate the jumpers on both the push button and chime

(see Figure 5).

3. The push button and chime both have eight different jumper locations. Jumper

positions 1 through 7 are used for setting the code.

1 2 3 4 5 6 7 8 9 ... 23 24

Žádné komentáře

Heath Zenith Wireless Plug-In Chime 598-1067-03 Uživatelský manuál Strana 4